How it Works Blucigs E-Cigs

Start with the Un-boxing…!

The first step is to open up the box.
Inside your Blu Starter Kit you will find:

• One Blu pack(*)
• Two Blu batteries
• One wall chargers
• One USB charger
• One variety pack (=5 Cartridges)

More info about un-boxing go here…!

Set Up for Initial Use…!

For optimal performance, fully charge the batteries and Blu pack before using Blu.

Attach a new flavor cartridge to the battery. Press Blu to your lips and inhale.

The blue LED light at the tip glows like a real cigarette to let you know it’s working.

Set Up/Initial Use more info go here…!

How to use Charging Pack…!

There are two ways to charge the Blu Original pack.
To charge the pack using the wall charger, plug the charger into the nearest outlet.
Connect the flat end end of the enclosed USB cable to the charger and the round end to the bottom of the pack. When the blue light at the end of the cord is on, the pack is charging. When the light turns off, your pack is fully charged.
To charge the pack using the enclosed USB charger, unplug the USB cord from the wall charger and connect one end of the cable to the pack,the other to USB port.
Charging Pack for more info go here…!

How to use Blu Pack as Battery Charger…!

Second slot of right, inside each pack, is a charge port. Screw the battery into the charge port until it is secure. The blue LED light on your battery will flash and the blue light on the side of the pack will light up.
When the light is on, the battery is charging.
When the light turns off, the battery is fully charged. Unscrew the battery from the charge port and store the battery there until needed.
Always make sure to unscrew the battery after charging. If the battery is left screwed into the receptor after charging it will drain the charge from the battery.
Blu Pack as Battery Charger more info here…!

How to replace the empty battery…!.

Secure the cartridge in one hand and unscrew the battery from the cartridge.
Grab the fresh battery from your Blu pack and reattach it to the cartridge.
When you’re finished, recharge the empty battery by screwing it back into the receptor. Remember to unscrew a newly charged battery from the receptor when the light on the side of the pack goes out. Note: During use, the LED light will flash 5 times to warn you that you are overusing your Blu and you should take a break.
For more info of  Replacing Batteries go  here…!

How to replace the cartridge…!

Hold the battery with one hand and unscrew the cartridge from the battery.

Take a new cartridge and screw it onto the battery and you are ready to resume.

Note: If you are leaving your Blu for a period of time and not using, unscrew the cartridge from the battery slightly so it is not activated while not in use.
If it’s not on, it’s not on – leave the plastic cap and leaf seal on your cartridges until you are ready to use them.
For more info of Replaying Cartridges go here…!